Raspberry Pi Lapdeck Wire Harness

In the Past post I showed you the parts you will need, So here are the Pictures of how I did it.

I got this piece...

Motorola Micro USB SKN6258 Adapter for RAZR2

 Then I cut off the mini male side of the cable, Leaving the female micro usb.

 Then I measured the case and 

how much cable I would need for this cable, 

and cut the excess off.

USB 1 ft Micro USB, A to Left angle micro B

 

Soldering Time!

 Here is the Layout

Make sure to cut your heat shrink and put it BELOW where you are soldering, 

on the wire BEFORE you start soldering

 

So here is the pictures of me hooking it up to the lapdeck and booting a couple OS's

Here is the Final Product! 

This is my second time doing this, and in the future, 

I'll be ether making a case that snaps on 

or another type of cable management. 

Raspberry Pi Lapdeck

Here is the list of cables and where you can buy them, to make your raspberry pi work with your lapdeck.

First You Need a Raspberry Pi here are 3 different places to get them from.

newark.com
alliedelec.com
mcmelectronics.com

Here is 2 different sites to find the atrix or bionic Lapdeck

amazon.com
ebay.com

Now here comes the fun!

You need a

1ft Micro HDMI Male to Micro HDMI Female

Micro USB B Male To Female M/F Cable

Here is a kit from Amazon that has both of the above, but the first time I bought the kit, the HDMI cable didn't work, the second time they did. So buyer beware!

Cable Adapter Set Motorola Atrix


You will also need a Micro HDMI to Full HDMI

HDMI Male to Micro HDMI C Female F/M

Depending on how you wire your pi, you will need a cable like this, to cut and solder together, like the Picture at the bottom on the page.

USB 1 ft Micro USB, A to Left angle micro B

One More Cable that you might need

Motorola Micro USB SKN6258 Adapter for RAZR2

Here is another Site that has different Pictures of cabling the Raspberry Pi.

http://kimondo.co.uk/raspberry-pi-modmypi-case-motorola-atrix-lapdock-raspberry-pi-laptop/

I am working on a few different designs. More to come.